In drywall construction, it is inevitable that some nail and screw pops will happen. The average home has 30,000 drywall screws that are holding the drywall panels in place. It’s only natural for a few of them to get knocked loose with time and use. There are steps you can take to minimize the risk of drywall pop-outs though. In this article we will discuss how a drywall contractor can prevent drywalls from coming down on your head!
Rule No.1: Get the moisture out of your lumber to prevent screws and nails from popping out
Drying your drywall and lumber is important to preventing nail pops. Make sure you keep them covered in a cool, dark place without any excess moisture for up ten days after cutting it if possible! You can also use silica packets or borax powder as an interior treatment before hanging the panels so they don’t shrink too much when exposed this way too – just be mindful of where those things are whenever you’re near them because we all know how tempting their delicious scent smells like…
Pops happen more often than not during installation due poor planning but there’s plenty that goes into mitigating their likelihood by taking certain steps early on such has following these simple guidelines: storing boards separately from one another; tracking what percentage (moisture content) drywall boards are; cutting drywall panels correctly (the smaller the better); and making sure to use nails that have correct depths.
Take inventory of your Materials
It’s crucial to make sure you have all the right materials before starting your drywall job. Having fasteners of the wrong length will cause them to move easily once it’s hung and this can lead into a lot more problems–not just an annoyance! You also need account for thickness when choosing nails, since long ones are harder on framing members than shorter ones might be because they’re hitting at different depths (5/8″ versus ¾”). In terms of screws vs nails: longer screw tend not only penetrate deeper but faster too-they usually go through both single layers as well as multiple types such as 2×4 wallboard or even gypsum boards themselves which may expand due to moisture.
Proper drywall installation is no easy task—there are a lot of things that need to be taken into account when hanging drywalls without pops–calling a professional drywall contractor can help!
Make sure you have proper positioning
The key to preventing pops in your next project is positioning. Screws should be set as deep into the drywall as possible without going all of the way through, and you’ll want them hidden from view by nailing boards over top or shimming with screws that are shorter than what’s sticking out on either side (you can also put glue up there instead). The most preventable causes for nail & screw popping? A failure during installation where they’re not pushed tight against stud walls while anchoring it- leading to voids around fastener holes which may lead laterally causing problems like this one!
More screws are not always better
The standard distance between screws or nails is 16 inches, but don’t try to set them closer together in hopes of a more tightly secured drywall. In reality this creates the risk for pops due simply to their presence with one fastener per corner and two within range. You should also avoid placing any further than 16″ away from any wall when installing nailing boards because there’s too much movement possible without approval adhesive that prevents it — you’ll be able to install things more securely this way!
You may be wondering why drywall pops happen and how you can prevent them. The answer is not as simple as it seems–there are a lot of factors involved in drywall installation, including the type of screws or nails used, where they’ve been hammered into place, and more! If you’re looking for some drywalls that won’t pop during installation due to improper materials choices (or just bad luck), then call us today at Calgary Drywall Doctor. We’ll work with you one-on-one to find out what went wrong so we can help identify solutions going forward. Remember: even if there’s no way around popping drywalls altogether, proper planning will go a long way towards minimizing their occurrence.
